Posted by Shane on May 09, 2000 at 20:37:16:
My front brake hasn't worked right since I have had it. When you would pull it it would hold the tire fine but it wouldn't release all the way. And then you would have to either kick the calipier to release it are hit it with a hammer. This weekend I took the calipier off and used wd40 to clean as I did the master cylinder. When I put it back together making sure everything was tight and no leaks. I couldn't bleed them I tried to even take the hose buy the M.C. off and see if it was getting any pressure and it wasn't. Does anybody know of a trick to bleeding the front brake. I know everything is good because it was locking the front wheel and that I will have to flush the wd40 out to have it work properly once I start getting fluid thourgh the system. Thanks for any advice.
Shane